Quartz Sleeve And Uv Lamp Inspection - Pentair SMART UV EU18-U Installation And User Manual

8
PRE-INSTALLATION INSPECTION
Quartz Sleeve and UV Lamp Inspection –
When Packed in Tube
SMART UV Disinfection Sterilizers are packaged
®
with their quartz sleeve assembly pre-assembled
inside the UV vessel.
The UV lamp is packaged separately in a corrugated
tube.
The Quartz Sleeve Assembly must be removed from
the UV vessel and inspected for damage prior to
installation. Extreme care should be used while this
procedure is being performed.
Note: DO NOT handle the lamp or quartz sleeve with
bare hands. Your hands can deposit oils on the quartz
sleeve and lamp that will decrease the efficiency of
UV disinfection.
1. Carefully unpack the UV lamp from their corrugated
packing tube and inspect for damage including
broken glass, cracks, chips, fractures and pin
holes. If damage has occurred please contact the
place of original purchase immediately.
NOTE: Save the corrugated lamp packaging after
unpacking the UV lamp. Storing the lamp and/or
quartz sleeve in this packaging while performing
maintenance on the UV system will protect these
components from damage or fouling when outside of
the vessel.
SMART UV® UV DISINFECTION STERILIZER Installation and User's Guide
2. Carefully, remove the quartz sleeve by unthreading
the Black Retaining Nut. Gently slide out the
quartz sleeve assembly and inspect for damage
including chips, cracks and pin holes. If damage
has occurred please contact the place of original
purchase immediately.
3. After inspection, reassemble the quartz sleeve
back into the UV vessel. Perform the Mandatory
Leak Test (see page 7).
4. Inspect all other UV system components (power
supply, UV vessel unions and necessary mounting
clamps) for damage.
After receipt and inspection of the unit, if broken
glass is found (including cracks, chips, pin holes
and hair line fractures of any kind) please contact
the place of original purchase immediately for
replacements.