Important Warning And Safety Instructions - Pentair SMART UV EU18-U Installation And User Manual

4
IMPORTANT NOTICE
This guide provides installation and operation instructions for the
SMART UV Sterilizer. Consult Pentair with any questions regarding
®
this equipment.
Attention Installer: This guide contains important information
about the installation, operation and safe use of this product. This
information should be given to the owner and/or operator of this
equipment after installation or left on or near the UV system.
Attention User: This manual contains important information that will
help you in operating and maintaining this product. Please retain it for
future reference.
IMPORTANT SAFETY INSTRUCTIONS! PLEASE READ PRIOR
TO INSTALLATION AND OPERATION!
Strictly follow the instructions within this manual to ensure the health
and safety of both, yourself and the UV system. The installation,
operation and maintenance of the UV system can only be carried out
after reading and understanding the information contained in this
manual.
The installation of the UV system must be carried out in accordance
with local regulations and codes.
READ AND FOLLOW ALL INSTRUCTIONS
This is the safety alert symbol. When you see this symbol on
your system or in this manual, look for one of the following signal
words and be alert to the potential for personal injury.
Warns about hazards that can cause death,
serious personal injury, or major property
damage if ignored.
Warns about hazards that may cause death,
serious personal injury, or major property
damage if ignored.
Warns about hazards that may or can cause
minor personal injury or property damage if
ignored.
NOTE Indicates special instructions not related to
hazards.
Carefully read and follow all safety instructions in this manual and
on equipment. Keep safety labels in good condition; replace if
missing or damaged.
SMART UV® UV DISINFECTION STERILIZER Installation and User's Guide
IMPORTANT SAFETY INSTRUCTIONS
When installing and using this electrical equipment, basic
safety precautions should always be followed, include the
following:
FAILURE TO FOLLOW ALL INSTRUCTIONS AND
WARNINGS CAN RESULT IN SERIOUS BODILY INJURY OR
DEATH.
INSTALLERS, OPERATORS AND OWNERS MUST READ THESE
WARNINGS AND ALL INSTRUCTIONS IN THE OWNER'S
MANUAL BEFORE USING THIS PRODUCT. THESE WARNINGS
AND THE OWNER'S MANUAL MUST BE LEFT WITH THE
OWNER.
Ultraviolet light is damaging to your eyes and skin! DO
NOT handle or stare at an operating UV lamp. Note that the UV light
rays are invisible to the human eye and precautions should be taken
to prevent UV energy from entering the eyes.
ULTRAVIOLET RADIATION. Disconnect all power
from the unit before replacing lamps or servicing the unit.
The quartz sleeve and or the UV lamp shipped with
this product may have been broken or damaged during transit. It
is therefore essential that the unit be carefully inspected before
connecting to electrical power.
To prevent possible fire or electrical shock, only use
replacement lamps specified by the manufacturer.
DO NOT allow system to exceed 50 PSI (Pounds Per
Square Inch).
DO NOT operate this unit above rated flow rate.
Operating the product in this manner may result in product failure
and voiding of warranty.
To avoid possible electrical shock, special care should
be taken since water is employed in intended applications. For each
of the following situation, DO NOT attempt repairs yourself. Call
Pentair customer service department at 877-347-4788 for services or
discard the appliance.
If unit falls into the water, DO NOT REACH FOR IT!
First power down the unit and then retrieve it. If the internal electrical
components of the unit get wet, keep the unit powered down until
internal electrical components have dried.
If the unit shows any sign of water leakage, immediately
power down the unit.
Carefully examine the unit after installation. It should
not be powered on if there is water on any part not intended to be wet.