Table of Contents
Advertisement
Endura AZ25 series probe
Combustion oxygen monitor
1.6 Restriction of Hazardous Substances (RoHS)
The European Union RoHS Directive and subsequent regulations introduced in member states and other countries limits
the use of six hazardous substances used in the manufacturing of electrical and electronic equipment. Currently,
monitoring and control instruments do not fall within the scope of the RoHS Directive, however ABB has taken the
decision to adopt the recommendations in the Directive as the target for all future product design and component
purchasing.
1.7 REACH directive
The candidate list according to Article 59 of the Regulation (EC) No 1907/2006 on the Registration, Evaluation, Authorisation and
Restriction of chemicals (REACH) continues to expand. Article 33 places a legal obligation on an article producer to inform recipients
of the information requirements when a candidate list substance is contained within an article at percentage of greater than 0.1% W/
W.
The AZ25 probe, product number AZ25/ all variants, aluminosilicates (CAS, 142844-00-6) a class 2 carcinogen, is contained at a
percentage marginally greater than 0.1% of the weight of the product. The material is totally enclosed within the product and should
pose no risk to the user during installation, use and decommissioning providing the probe is handled in accordance with the
instructions defined in the user manual. The probe should be disposed of as hazardous waste.
Further information on refractory ceramic fibers can be found at Fiberfrax,
Chemicals Hazards Agency) websites.
1.8 Safety precautions
Please read the entire manual before unpacking, setting up, or operating this instrument.
Pay particular attention to all warning and caution statements. Failure to do so could result in serious injury to the operator or damage
to the equipment.
To ensure the protection provided by this equipment is not impaired, do not use or install this equipment in any manner other than
that which is specified in this manual.
1.9 Safety conventions
Warning. In this manual, a warning is used to indicate a condition which, if not met, could cause serious personal injury and / or
death. Do not move beyond a warning until all conditions have been met.
If a warning sign appears on the instrument itself, refer to Precautionary Labels – UL Certification and Electrical Safety – CEI / IEC
61010-1:2001-2 for an explanation.
Caution. A caution is used to indicate a condition which, if not met, could cause minor or moderate personal injury and / or
damage to the equipment. Do not move beyond a caution until all conditions have been met.
Note. A note is used to indicate important information or instructions that should be considered before operating the equipment.
4
www.Fiberfrax.com
and on the ECHA (European
1 Safety
OI/AZ25P–EN Rev. E
Advertisement
Table of Contents
