Table of Contents
Advertisement
Endura AZ25 series probe
Combustion oxygen monitor
1 Safety
Information in this manual is intended only to assist our customers in the efficient operation of our equipment. Use of this manual for
any other purpose is specifically prohibited and its contents are not to be reproduced in full or part without prior approval of the
Technical Publications Department.
1.1 Health & Safety
Health and Safety
To ensure that our products are safe and without risk to health, the following points must be noted:
The relevant sections of these instructions must be read carefully before proceeding.
Warning labels on containers and packages must be observed.
Installation, operation, maintenance and servicing must only be carried out by suitably trained personnel and in accordance
with the information given.
Normal safety precautions must be taken to avoid the possibility of an accident occurring when operating in conditions of
high pressure and / or temperature.
Safety advice concerning the use of the equipment described in this manual or any relevant Material Safety Data Sheets (where
applicable) may be obtained from the Company address on the back cover, together with servicing and spares information.
1.2 Electrical safety – CEI / IEC 61010-1:2001-2
This equipment complies with the requirements of CEI / IEC 61010-1:2001-2 'Safety Requirements for Electrical Equipment for
Measurement, Control and Laboratory Use' and complies with US NEC 500, NIST and OSHA.
If the equipment is used in a manner NOT specified by the Company, the protection provided by the equipment may be impaired.
1.3 Symbols – CEI / IEC 61010-1:2001-2
One or more of the following symbols may appear on the equipment labelling:
Protective earth (ground) terminal.
Functional earth (ground) terminal.
Direct current supply only.
Alternating current supply only.
Both direct and alternating current supply.
The equipment is protected through double insulation.
This symbol, when noted on a product, indicates a potential hazard which could cause serious personal injury and / or
death.
The user should reference this instruction manual for operation and / or safety information.
This symbol, when noted on a product enclosure or barrier, indicates that a risk of electrical shock and / or electrocution
exists and indicates that only individuals qualified to work with hazardous voltages should open the enclosure or remove
the barrier.
This symbol indicates that the marked item can be hot and should not be touched without care.
This symbol indicates the presence of devices sensitive to electrostatic discharge and indicates that care must be taken
to prevent damage to them.
This symbol identifies a risk of chemical harm and indicates that only individuals qualified and trained to work with
chemicals should handle chemicals or perform maintenance on chemical delivery systems associated with the
equipment.
2
1 Safety
OI/AZ25P–EN Rev. E
Advertisement
Table of Contents
