Mira Orbis Installation And User Manual page 22

1.
Switch on the electrical supply and
press the 'Start/Stop' button
3.
Set to the desired position.
5.
Allow 10 - 15 seconds for any temperature adjustments to reach the handset.
6.
Press STOP button, the light on the button
goes out. The Shower flow will continue for a
few seconds before stopping. Switch off the
electrical supply.
Note! After 40 minutes of continuous use, the
shower will automatically switch OFF.
Note! At the end of every shower make sure that the shower head points into the
catchment area. A small amount of water may be retained in the shower handset
after the shower has been turned off. This may drain over a few minutes.
2.
The temperature indicator becomes
illuminated.
4.
Check the water temperature before
entering shower.
7.
Residual water may drain over a
few minutes.
22
Temperature
of Shower
Clock