Let's Talk Technical - Vax TBT3V1B1 Let's Get Started

Removing blockages from the handheld and reach wand
Press the handheld
release button and
remove the reach
wand. Check and clear
any dirt and debris from
this connection point.
Removing blockages from the Powered Head
IMPORTANT: If the brushbar has been obstructed, the motor protection sensor may have been activated.
The brushbar will stop and the light on the Powered Head will illuminate red. To reset, remove the
Powered Head from the reach wand/handheld and clear any obstruction. Wait 1 minute before refitting
the Powered Head, switch the slim vac on and press the brushbar on/off button.
Press the Powered
Head/ accessory release
clip and pull to remove
the Powered Head from
the reach wand.
To test for a blockage in the reach wand, drop a small
ball of paper into the wand. The paper will drop
through if the wand is clear. Use a broom handle or
similar blunt object to remove any blockage.
Check the Powered
Head for any blockages
and use a blunt object to
remove the blockage.

Let's talk technical

Using scissors, remove
any threads or hair from
around the brushbar and
clear any dirt or debris
from the Powered Head.