Let's Talk Technical - Vax U86-AL-B Manual

Clearing a blockage from the brushbar
IMPORTANT: If the brushbar has been obstructed the Motor Protection Sensor may have been activated. Remove the battery
and dirt container and clear any obstruction. Wait 30 minutes for the vacuum cleaner to reset itself. Replace the battery and
dirt container, recline and switch on the vacuum cleaner. If the brushbar still does not turn press the brushbar On/Off button.
Remove battery and lie
the vacuum cleaner flat.
Squeeze the clips on the
brushbar cover towards
the brushbar and lift off
brushbar cover.
Changing the brushbar
Remove battery and lie the
vacuum cleaner flat.
Squeeze the clips on the
brushbar cover towards
the brushbar and lift off
brushbar cover.
Using a pair of scissors
cut any hair or debris from
around the brushbar.
Remove brushbar firstly
lifting the side of brushbar
not connected to belt.

Let's talk technical

Replace the brushbar cover
by clicking into place.
Re fit brushbar, fitting the
belt to the brushbar first.
Then aligning both sides
of the brushbar into base.
Refit the brushbar cover
by clicking into place.