Let's Talk Technical - Vax Cordless Slim Vac Series Manual

IMPORTANT: If the brush bar has been obstructed, the motor protection sensor may have been activated, the light
will flash Red and the brushbar will seize. Remove the Powered Head from the machine and clear any obstruction.
Refit the Powered Head, switch on the vacuum cleaner by pressing the trigger and press the brushbar on/off button.
Removing and replacing the brushbar
Slide to release the
brushbar. The cover
can not be removed.
Removing blockages from the Powered Head
Removing blockages from reach wand
Lift to remove the left side
of the brushbar first.
The brushbar should be removed from the Powered
Head before attempting to remove any blockages.
Using scissors remove any threads or hair from
around the brushbar and clear any dirt or debris
from Powered Head.

Let's talk technical

Clear any threads or hair
from both ends of the
brushbar and any dirt/
debris inside the housing
of the Powered Head.
To test for a blockage in the reach wand, drop a small
ball of paper into the wand. The paper will drop through
if the wand is clear. Use a broom handle or similar blunt
object to remove any blockage.
When re-fitting the
brushbar fit the right side
into the housing first.
Then line up and slot into
place the left side.