Subscribe to Our Youtube Channel
Related Manuals for Texas Instruments EK-TM4C123GXL-BOOSTXL-SENSHUB
Summary of Contents for Texas Instruments EK-TM4C123GXL-BOOSTXL-SENSHUB
- Page 1 EK-TM4C123GXL-BOOSTXL-SENSHUB Firmware Development Package USER’S GUIDE SW-EK-TM4C123GXL-BOOSTXL-SENSHUB-UG-2.1.4.178 Copyright © 2012-2017 Texas Instruments Incorporated...
-
Page 2: Copyright
Thumb are registered trademarks and Cortex is a trademark of ARM Limited. Other names and brands may be claimed as the property of others. Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas Instruments semicon- ductor products and disclaimers thereto appears at the end of this document. -
Page 3: Table Of Contents
Table of Contents Table of Contents Copyright ........... . . Revision Information . - Page 4 Table of Contents February 22, 2017...
-
Page 5: Introduction
Introduction Introduction The Texas Instruments® Tiva™ C Series EK-TM4C123GXL is a low cost platform that can be used for software development and to prototype a hardware design. A variety of BoosterPacks are available to quickly extend the LaunchPads features. This document describes the example applications that are provided for the EK-TM4C123GXL when paired with the BOOSTXL-SENSHUB BoosterPack. - Page 6 Introduction February 22, 2017...
-
Page 7: Example Applications
These applications are intended for demonstration and as a starting point for new applications. There is an IAR workspace file (ek-tm4c123gxl-boostxl-senshub.eww) that contains the peripheral driver library project, USB library project, and all of the board example projects, in a single, easy to use workspace for use with Embedded Workbench version 6. -
Page 8: Nine Axis Sensor Fusion With The Mpu9150 And Complimentary-Filtered Dcm (Compdcm_Mpu9150)
Example Applications Wiki at http://processors.wiki.ti.com/index.php/Tiva_C_Series_LaunchPad and http://processors.wiki.ti.com/index.php/Wireless_Air_Mouse_Guide. Nine Axis Sensor Fusion with the MPU9150 and Complimentary-Filtered DCM (compdcm_mpu9150) This example demonstrates the basic use of the Sensor Library, TM4C123G LaunchPad and Sen- sHub BoosterPack to obtain nine axis motion measurements from the MPU9150. The example fuses the nine axis measurements into a set of Euler angles: roll, pitch and yaw. -
Page 9: Pressure Measurement With The Bmp180 (Pressure_Bmp180)
Example Applications Pressure Measurement with the BMP180 (pres- sure_bmp180) This example demonstrates the basic use of the Sensor Library, TM4C123G LaunchPad and the SensHub BoosterPack to obtain air pressure and temperature measurements with the BMP180 sensor. Connect a serial terminal program to the LaunchPad’s ICDI virtual serial port at 115,200 baud. Use eight bits per byte, no parity and one stop bit. -
Page 10: Important Notice
IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, enhancements, improvements and other changes to its semiconductor products and services per JESD46, latest issue, and to discontinue any product or service per JESD48, latest issue. Buyers should obtain the latest relevant information before placing orders and should verify that such information is current and complete.
Need help?
Do you have a question about the EK-TM4C123GXL-BOOSTXL-SENSHUB and is the answer not in the manual?
Questions and answers