Advertisement
Precautions for Use
These instructions are to ensure the product is used correctly, safely, and to prevent any possible risk or damage to the user
and/or others people. Our company shall not take any responsibility for any failure of product, malfunction and damages
caused by improper use by the user or third parties.
DANGER
Follow all directions below to prevent
Follow all directions below to prevent
serious injury.
DANGER
Do not use for ammable liquids or
Make sure the pump is tightly
concentrated acids.
secured to the drum(tank) before
turning the pump on.
Be cautious. This pump does not
have an explosion proof motor.
Do not refuel directly while the
vehicle or equipment is turned on.
Do not use near the ammable
materials such as gasoline, gas, etc.
Do not leave the pump unattended.
Only use on applicable liquids
Do not bend, bind or pull the power
written on the speci cations.
cord by force.
Make sure to use the pump on even
surface.
Do not allow children to operate the
product without adult supervision.
Names of Parts
Toggle Switch
Operating lamp(LED)
2
WARNING
CAUTION
Follow all directions below to prevent
serious injury.
serious injury.
WARNING
CAUTION
After using the pump, do not keep it
on its side or upside down.
Make sure to remove any left-over
liquid in the discharge hose after
each use.
Do not alter or disassemble the
pump.
Do not run the pump 'dry' or let the
pump idle without transferring.
Make sure to turn o the power after
using the pump.
Do not shock the pump.
Do not use deteriorated or
contaminated liquids and fuels.
Do not place the pump in a wet area.
Do not use this pump for hot liquids
above 40°C (104°F ).
Nozzle holder
Nozzle
Drum bung adapter
Suction pipe
Discharge hose
Speci cations
Delivery volume
Approx. 5 Gallons
Suction pipe length
Approx. 850 ~ 33.5"~ 34"
Discharge hose length
Approx. 10 ft
Diesel, DEF(AdBlue), Water, Kerosene, Antifreeze, Windshield washer uid,
Applicable liquids
Mild detergents, Agricultural chemicals, Light oils.
Directions for Use
1
2
Insert the suction pipe into the
Tighten the drum bung adapter.
drum .
4
5
Place the nozzle into the receiving
Toggle switch ON(Up).
container to transfer liquid.
7
8
Release the lever when the liquid
Toggle switch OFF(Down).
supply is completed.
10
11
Let the left-over liquid in the hose
Insert the nozzle in the nozzle holder
ow back into the drum (tank).
for storage.
Operating temperature
+5˚C ~ 40˚C (41˚F ~ 104˚F)
Operating voltage
DC12V ~ 20V
5A
Fuse
3
Pull out the nozzle from the
nozzle holder.
6
Pull the nozzle lever and start
supplying the liquid.
9
Pulling the lever of the nozzle,
lift it up.
3
Advertisement
