Onset Installation - Miele KMDA 7774 FL User Manual

Onset installation

 Prepare the worktop cut-out Remem-
ber to maintain the minimum safety
distances (see "Safety distances").
 Seal the cut surfaces on wooden
worktops with a suitable heat-resist-
ant sealant to avoid swelling caused
by moisture. The sealant must be
temperature-resistant.
Make sure that the sealant does not
come into contact with the top of the
worktop.
 Attach the seal provided underneath
the edge of the hob.
 Feed the mains connection cable
down through the cut-out.
 Place the hob centrally in the cut-out.
When doing this make sure that the
seal of the appliance sits flush with
the worktop on all sides. This is im-
portant to ensure an effective seal all
round.
Do not use any additional sealant
(e.g. silicone) on the hob.
If the seal does not meet the worktop
correctly on the corners, the corner ra-
dius (≤ R4) can be carefully scribed to
suit.
 Connect the hob to the mains.
 Check that the hob works.
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
Installation
81