Control Panel Overview - Pentair Sta-rite EnviroMAX 1500 Installation, Operation And Service Manual

2

CONTROL PANEL OVERVIEW

Control Panel Overview
(1) Speed Buttons
(2) External
Control Only
LED Indicator
(3) Start/Stop
Button
If power is connected to the SuperFlo
following buttons referred to in this section could result in the motor starting. Failure to recognize this
If power is connected to the EnviroMAX 1500 Variable Speed Pump motor,
pressing any of the following buttons referred to in this section could result in
the motor starting. Failure to recognize this could result in personal injury or
Keypad Navigation
Keypad Navigation
1. Speed Buttons - Used to select the run speed desired. The LED above the Speed Buttons will illuminate
1. Speed Buttons - Used to select the run speed desired. The LED above the Speed Buttons will
when that speed is selected or is currently running. A flashing LED indicates that an External Control is
active on that speeds channel. illuminate when that speed is selected or is currently running. A flashing LED indicates that an
External Control is active on that speeds channel.
2. External Control Only LED Indicator - Indicates that the pump is operating in External Control Only
2. External Control Only LED Indicator - Indicates that the pump is operating in External Control Only
mode. When LED is illuminated the schedule is disabled and the only input is from the low voltage external
mode. When LED is illuminated the schedule is disabled and the only input is from the low voltage
controls.
external controls.
3. Start/Stop Button - Used to Start and Stop the pump. When the pump is stopped and the LED is not
3. Start/Stop Button - Used to Start and Stop the pump. When the pump is stopped and the LED is not
illuminated, the pump is unable to run from any type of input.
illuminated, the pump is unable to run from any type of input.
4. Display Mode LED Indicators - An illuminated LED indicates the information being displayed on the
4. Display Mode LED Indicators - An illuminated LED indicates the information being displayed on the screen
screen at any specific point. A flashing LED indicates that the parameter is currently being edited.
at any specific point. A flashing LED indicates that the parameter is currently being edited.
5. Display Button - Used to toggle between the different available display modes. This button is also
5. Display Button - Used to toggle between the different available display modes. This button is also used to
used to set the 24-hour clock and screen resolution.
set the 24-hour clock and screen resolution.
6. Quick Clean Button - Used to run a selected speed and duration programmed for Quick Clean. When
6. Quick Clean Button - Used to run a selected speed and duration programmed for Quick Clean. When the
the LED is illuminated the Quick Clean schedule is active.
LED is illuminated the Quick Clean schedule is active.
7. Power LED Indicator - An illuminated LED indicates that there is live power being supplied to the
pump.
7. Power LED Indicator - An illuminated LED indicates that there is live power being supplied to the pump.
8. "+" and "-" Arrows - Used to make on screen adjustments to the pump settings. The "+" arrow
8. "+" and "-" Arrows - Used to make on screen adjustments to the pump settings. The "+" arrow increases
increases the value of a given setting, while "-" decreases the value of a given setting. Pressing and
the value of a given setting, while "-" decreases the value of a given setting. Pressing and holding down
holding down either arrow button will increase or decrease the incremental changes faster.
either arrow button will increase or decrease the incremental changes faster.
SUPERFLO VS Variable Speed Pump Installation and User's Guide
®
Operation
CAUTION
® VS Variable Speed Pump motor, pressing any of the
could result in personal injury or damage to equipment.
damage to equipment.
(4) Display Mode
LED Indicators
(5) Display Button
(6) Quick Clean
Button
(7) Power LED
Indicator
(8) "+" and "-"
Arrows
10