Output Power Selection - Midland CT3000 Instruction Manual

Transmitting
Before transmitting on the frequency or channel you have set, please check
they are not busy.
Press PTT and speak towards the microphone.
While you are transmitting, TX will appear on the display as well as the indicator
of the output power signal strength. Release the PTT to receive.

Output power selection

You can set three different output power levels: high (25W), middle (10W),
low (5W).
Press POW on the front panel of the radio. Everytime POW is pressed, the
output power indicator in the lower part of the display will show: POW:HI (high
power) , POW:LO (low power) , POW:MI (middle power).
The output power can be selected also with the microphone: press PC on the
mike; at every pressure, the output power will change.
Note: you can set different output powers for the two bands A and B.
Keypad lock
To lock the keypad keep pressed the main knob for 2 seconds. Key Lock will
appear in the lower side of the display.
Now all controls (radio and mike) will be locked except PTT.
To unlock the keypad keep presssed the main knob for 2 seconds again.
12 | Midland CT3000 instruction guide