Table of Contents
Advertisement
Operations
Power on/off and volume adjustment
Rotate the Power/Volume knob clockwise to turn the radio on.
Rotate the control clockwise /counter-clockwise to adjust the volume level as you
prefer.
Rotate the control counter-clockwise till hearing a mechanical "click", to turn the
radio off.
Transmission
To communicate, all radios in your group must be set to the same channel.
Briefly press the Function key 1 to enable the Monitor feature in order to make sure
that the frequency is not busy, then press the PTT button.
Release the PTT key to receive.
Only one user at a time can talk during radio communications. Therefore, it is important
not to transmit when you are receiving a communication and use the transmission mode
sparingly to allow other users to use the feature.
Transmission consumes a significant amount of energy and should therefore be used
sparingly to prolong the battery life.
If you are unable to contact a station that you have no problems in receiving, the station
may be using CTCSS tones or DCS codes.
Monitor
The Monitor feature is for temporarily excluding (opening) the Squelch, in order to
listen to signals that are too weak to keep the Squelch permanently opened.
Briefly press the Function key 1 to enable such function.
Scan
Keep pressed the Function key 2 for about 2 sec. to enable the SCAN function: the
radio will scan all channels from the channel in use.
Whenever any signal is detected, the radio will suspend the Scan; to resume scan-
ning, press again the PTT button.
The scanning will be done on the frequency band in use, so either channels 1-16 or
17-32.
6 |
Midland G11 PRO instruction guide
Advertisement
Table of Contents
