Installing The Fuselage Servos - RED BARON PIZZA SQUADRON’S STEARMAN Assembly Manual

55mm
M3 lock nut.
M3 clevis.

INSTALLING THE FUSELAGE SERVOS.

Because the size of servos differ, you
may need to adjust the size of the precut
opening in the mount. The notch in the
sides of the mount allow the servo lead to
pass through.
1) Install the rubber grommets and brass
collets into all servos. Test fit the servos
into the fuselage servo mounts.
2) Secure the servos with the screws pro-
vided with your radio system.
Elevator servo.
Elevator servo.
.
Throttle servo.
Rudder servo.
THROTTLE SERVO ARM
Install adjustable servo connector in the
servo arm as same as picture below:
Loctite secure.
Elevator servo arm.
Elevator servo arm.
.
INSTALLING THE RECEIVER SWITCH.
Install the switch into the precut hole in
the side, in the fuselage.
.
INSTALLATION.
Adjustable servo
connector.
Servo arm.
Throttle servo arm.
Rudder servo arm.
3/32" Hole.
Trim and cut.
7