RED BARON PIZZA SQUADRON’S STEARMAN Assembly Manual page 34

STEARMAN 71.5 inches
2) Use a 2.5mm hex wrench to remove the
screws that attach the panels to the fuse-
lage and center section. Slide the panels
from the tubes and disconnect the servo
lead for the aileron servo.
34
Instruction Manual.
Using the transport frames allow the re-
moval of the wings without the need to
remove the aileron linkage and the inter-
plane strut between the top and bottom
wings.
INSTALLATION PILOT AND
WINDSHIELD.
1) Locate items necessary to install pilot
and windshield.
.
2) A scale pilot is included with this ARF.
The Pilot included fits well in the cockpit.
(or you can order others scale pilot fig-
ures made by SG Models. They are avail-
able at SG Models distributors.).
If you are going to install a pilot figure,
please use a sanding bar to sand the base
of the figure so that it is flat.
3) Position the pilot figure on the cock-
pit floor as shown. Use epoxy to glue the
base of the pilot figure, please see pictures
as shown.