Installing The Spinner; Hinging The Elevators; Installing The Horizontal Stabilizer - RED BARON PIZZA SQUADRON’S STEARMAN Assembly Manual

INSTALLING THE SPINNER.

Install the spinner backplate, propeller
and spinner cone.
The propeller should not touch any
part of the spinner cone. If it does, use a
sharp modeling knife and carefully trim
away the spinner cone where the propel-
ler comes in contact with it.

HINGING THE ELEVATORS.

Glue the elevator hinges in place using
the same techniques used to hinge the ai-
lerons.
INSTALL ELEVATOR CONTROL HORN.
Fiberglass control horn
Elevator fiberglass control horn.
INSTALLING THE HORIZONTAL
STABILIZER.
1) Using a ruler and a pen, locate the cen-
terline of the horizontal stabilizer, at the
trailing edge, and place a mark. Use a tri-
angle and extend this mark, from back to
front, across the top of the stabilizer. Also
extend this mark down the back of the
trailing edge of the stabilizer.
Epoxy.
Epoxy.
Draw center line
21