Installation Cable; Removing The Wing Panels - RED BARON PIZZA SQUADRON’S STEARMAN Assembly Manual

INSTALLATION CABLE.

1) Prepare one end of the cable by at-
taching a cable end using a copper crimp.
Thread a nut, then a clevis, on the cable
end as shown. Prepare only one end of
each cable at this time.
Crimp
M3 clevis
2)Attach the clevis to the brass tab next to
the rear interplane strut on the upper-
lower wing.Slide a copper crimp on the
cable. Pass the cable through the brass tab
on the upper wing, the back through the
copper crimp.
Metal Cable.
M3x30mm

REMOVING THE WING PANELS

Begin placing tension on the wires,
working from the ends that have been
crimped to the ends that have not. There
should be light tension on all the cables,
but not enough to change the position
of the wing. Once the cables have been
tensioned, begin by securing the crimps
where the cables pass through the tabs
near the fuselage. Then secure the crimps
at the cable ends. Once tensioned, use
side cutters to trim the excess cable.
1) Locate the wing transport frams and
rubber bands. Slide the frames between
the top and the bottom wing as shown.
Use a rubber band to hold the frame to
the top and bottom wing.
33