Vent Control - Toshiba RAC-H07CR Owner's Manual

Operation instructions
EN
SLEEP MODE (RAC-H**CR series only):
cooling mode the cooling temperature set point will
increase 1 O
selected. Two hours later, temperature and the fan
reduce the noise and create a comfortable sleeping
environment.
Note: This feature is not available under DRY and
FAN ONLY operation.
SWING keypad:
(oscillation) feature. The green indicator light
selected mode is operating. The vertical louvers will
move from (side to side) automatically, sweeping air
alternately for comfortable cooling. To stop the air
indicator light adjacent to the keypad will go off.
m o d e w h i c h c a n r e d u c e n o i s e a n d c r e a t e a
comfortable sleeping environment. When the
UNIT OPERATIONS
AUTO operation(if available):
Auto mode.
The unit will select the appropriate operating mode
from Fan or Cool based upon the temperature
difference between the actual and desired room
temperature. If the actual room temperature is 2
above the set point, the unit operates in cooling
mode. When the actual room temperature is 1
higher above the set point but 2 o C lower below the
set point, the unit will select the Fan mode.
Note:
09
DRY operation (RAC-H**CR series only):
In the Dry mode, the air conditioner will generally
s p a c e i s a c l o s e d o r s e a l e d t h e r o o m d r o p
temperature.
COOL operation:
The temperature setting are adjustable
16 o C to 31 o C for RAC-H**B series
;
o o
17 C to 30 C for RAC-H**CR series
Cooling begins automatically when the room
o above the set point, and
temperature is 1
C
stops when the room temperature is 1
the set point. The fan will not stop running.
Failure Indicator Display:
Indicates a malfunction of the indoor room
temperature sensor.
Indicates a malfunction of the evaporator
temperature sensor.
Indicates a malfunction of the outdoor condenser
temperature sensor.
Note:
When one of the above malfunctions occurs,
turn off the unit, and check for any obstructions.
Restart the unit, if the malfunction is still present,
turn off the unit and unplug the power cord.
Contact the manufacturer or its service agents
or a similar qualified person for service.
Indicates frosting protection (Turn off the unit and
restart it to return to normal operation).
o C
o
C
CONTROL PANEL COVER
1. Grasp the top of the control panel cover and pull it
downwards to open it.
2. Close the control panel cover and press the top of
the operation cover again until it snaps into the
locked position.
as below:
.
o
C below
Note: Don't press or swing the opened
operation cover.
ADJUST AIR FLOW DIRECTION
panel, the vertical louvers will automatically swing right
and left sweeping the cold air alternately to obtain
comfortable cooling. The vertical louvers may be
Operation instructions
To adjust vertical air flow direction, adjust any one of
the horizontal louver blades. When turning up or down
the horizontal louver blades, always keep the blades
horizontality. This can effectively prevent water drops
condensed on the front panel of the unit.
Vertical air flow adjustment (manually)

VENT CONTROL

To open the vent, set the lever To open the vent, pull the lever
to the right position; To close it, toward you; To close it, push it in.
set the lever in the left position.
Model: Model:
The vent control is located above the control panel.
.
The control method is different on different models as
shown above.
discharge stale air.
NOTE: The VENTILATION LEVER should normally be
only for ventilation.
CAUTION
Clean your air conditioner occasionally to keep the
appearance in good condifion. Be sure to unplug the
unit before cleaning to prevent chock or fire hazards.
EN
10