ElectrIQ AIRFLEX15 User Manual page 4

 Always place the unit on a dry and stable surface.
 The appliance should not be installed in laundry or wet rooms
 The appliance must be placed in a room without sources of ignition (for example:
open flames, an operating gas appliance or an operating electric heater).
 R290 refrigerant gas complies with European environmental directives.
 R290 has a low GWP (Global Warming Potential) of 3.
 The air conditioner contains about 235 g of R290 refrigerant gas.
 Do not use or store in an unventilated space with an area smaller than 11.3m
unit. The room must be such as to prevent stagnation of possible leaks of
refrigerant gas as there could be a danger of fire or explosion hazard should the
refrigerant come into contact with electric heaters, stoves or other sources of
ignition.
 If the appliance is installed, used or stored in an unventilated room, the room must
be such as to prevent stagnation of possible leaks of refrigerant gas as there could
be a danger of fire or explosion should the refrigerant come into contact with electric
heaters, stoves or other sources of ignition.
 Refrigerant gas may be odourless.
 Do not use the product and contact the retailer for advice, if damage has occurred
to the unit which may have compromised the refrigerant system.
 Any repairs or maintenance must only be carried out on the unit by a suitably
qualified engineer. Before opening and servicing the unit the authorized engineer
must be in possession of a copy of the manufacturer's service manual and must
follow the safety information contained within it to ensure all hazards are minimized.
 The refrigerant system should not be perforated or punctured.
Energy Saving and Unit Safety Protection Tips
 Do not cover or restrict the airflow from the outlet or inlet grills.
 For maximum performance the minimum distance from a wall or objects should be
50cm. The unit is fitted with a thermal cut off sensor that will prevent overheating.
 Keep the filters clean. Under normal conditions, filters should only need cleaning
once every three weeks (approximately). Since the filters remove airborne particles,
more frequent cleaning maybe necessary, depending on the air quality.
 For the initial startup set the fan speed to maximum and the thermostat to 4-5
degrees lower than the current temperature. After, set the fan switch to low and set
the thermostat to your desired setting.
 To protect the unit we recommend not using the cooling function when the ambient
temperature is higher than 32°C.
 To protect the unit we recommend not using the heating function when the ambient
temperature is lower than 7°C. Use alternative heating to raise the room
temperature to 10°C than start the air conditioner in heat mode and set it to the
desired temperature. Heating by heat pump will take longer but is much more
efficient than any other form of heating and ideal for maintaining a constant room
temperature.
Page 4 of 24
2 per