Grizzly T1213 Instructions

For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com
Introduction
The Model T1213 Resaw Drift Bar is designed
to help reduce blade lead (cut drift) by creating
a pivot point on the resaw fence that provides
more control during resaw operations. It can be
installed on any resaw fence at least 5
NOTICE
Installation of Model T1213 requires per-
manent modification of your resaw fence!
Before installing Model T1213, make sure
blade guides clear the top of resaw fence
by at least ⁄ ".
1
2
Figure 1. Model T1213 Resaw Drift Bar.

Specifications

Weight .........................................................2 lbs.
Dimensions ......................................6
Minimum Fence Height .................................5
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
⁄ " tall.
7
8
⁄ "L x 1
1
4
COPYRIGHT © AUGUST, 2017 BY GRIZZLY INDUSTRIAL, INC.
NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
#ES19023 PRINTED IN TAIWAN
RESAW DRIFT BAR
Recommended Tools
Drill w/Guide or Drill Press ................................ 1
Drill Bit
3
Center Punch..................................................... 1
Tape Measure .................................................... 1
Installation
1. DISCONNECT MACHINE FROM POWER!
2. Install a blade suitable for resaw operations.
We suggest widest possible blade for your
machine with 2–4 TPI (hook or skip teeth)
that is sharp and clean.
3.
Install resaw fence and move it up to blade.
If resaw fence is adjustable forward/back,
make sure blade is centered lengthwise on
resaw fence.
4.
Mark top of resaw fence exactly
blade teeth (see Figure 2).
5. Mark a point exactly
Step 4 (see Figure 2).
Center
Mark
⁄ "D
1
4
⁄ "
7
8
Resaw
Fence
Figure 2. Location of center mark and hole point.
MODEL T1213
INSTRUCTIONS
⁄ " ......................................................... 1
8
⁄ " below mark made in
13
16
⁄ "
13
16
Drill
Here
⁄ " forward of
1
4
⁄ "
1
4
Blade
V1.10.17