Advertisement
6.
Remove resaw fence from bandsaw.
7.
Use center punch to score a point at mark
made in Step 5 and drill
resaw fence.
Note: Use drill press or handheld drill with
guide to make sure hole is drilled perpendicu-
lar to resaw fence.
8.
Insert adjustable handle with fender wash-
er through back of resaw fence (refer to
Parts Breakdown drawing).
9.
Make sure drift bar is flat against resaw fence
and straight up and down.
Operation
1.
Install resaw fence with drift bar.
2.
Mark cut line from front to back on top of
workpiece (see Figure 3).
3.
Lower bandsaw blade guides as close to
workpiece as possible (see Figure 3).
4.
Adjust resaw fence so blade aligns with mark
made in Step 2 and center of drift bar is set
⁄
" forward of blade teeth (see Figure 3).
1
4
Blade
Drift
Bar
1/4"
Drift
Bar
Figure 3. Workpiece positioned to cut using
resaw fence with drift bar.
5.
Lock rip fence and resaw fence in position.
-2-
⁄
" hole through
3
8
Blade
Guides
Blade
Cut Line
Mark
Workpiece
6.
If necessary for cutting operation, support
ends of board with saw stand or roller stand.
7.
Turn bandsaw ON.
8.
Slowly feed workpiece completely through
blade. Use drift bar as a pivot point to control
cut, as shown in Figure 4.
Note: The drift bar allows you to steer your
workpiece while cutting to quickly correct
blade lead and keep blade aligned with cut
line.
Blade
Drift
Bar
Figure 4. Resawing with drift bar.
Parts Breakdown & List
2
1
REF PART #
DESCRIPTION
1
PT1213001
ADJ HANDLE 65L, M8-1.25 X 25
2
PT1213002
FENDER WASHER 8MM
3
PT1213003
RESAW DRIFT BAR 6-1/4" X 1-1/4"
BUY PARTS ONLINE AT GRIZZLY.COM!
Scan QR code to visit our Parts Store.
Blade
Guides
Cut Line
Mark
Workpiece
3
Advertisement
