4.4 Mid Cover
1.
Remove the main board and bottom cover
first
2.
Pull the mid cover downward and take out it.
(Figure D-1)
Warning:
Always turn off printer power before removal.
Before replacing TPH, please wait for the
printer head temperature to cool.
4.5 Motor
1.
Remove the mid cover of the printer first,
and then cut cable tie which locates the
cable of motor as shown in Figure E-1.
2.
Using screwdriver to loosen the 3 screws
from the printer module. (Figure E-2)
3.
Take the motor as shown in Figure E-3
Warning:
Always turn off printer power before removal.
Caution:
When disconnect the power cord, please wait
10 seconds after removing any connectors
from the printer.
Wait for the motor temperature to cool.
D-1
E-1
15