Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for PowerBox Systems PowerBox 12
Summary of Contents for PowerBox Systems PowerBox 12
- Page 1 Operating Instructions...
- Page 2 POWER BOX 12...
- Page 3 The charge socket is separated from the inside of the switch by a partition, so that the PowerBox 12 is also very well protected against dust and dirt penetration.
- Page 4 POWER BOX 12 Both batteries can be charged simultaneously by means of the integral charge socket fitted to the switch case (MPX connector: increased current capacity), provided that a standard battery charger is used, e.g. the Robbe Lader 5, Graup- ner Multilader 6, Titan etc.
- Page 5 POWER BOX 12 Please do not throw away the inner packaging immediately, as it includes a tem- plate for marking the switch aperture. Cut or saw outside the marked line, as shown in the photo. Even though our product is very well protected from the effects of vibration, the switch should always be mounted in a part of the model relatively low in vibration.
- Page 6 Please note that Li-Po cells must not be connected directly to the receiving system or the PowerBox 12 battery backer! The voltage of a two-cell Li-Po pack is excessive, and must be reduced to the normal prescribed voltage for the receiver and servos (max.
- Page 7 PB 12 JR grey • 6120 PB 12 MPX black • 6125 PB 12 MPX grey We wish you every success using your new PowerBox 12 switch backer, and hope you have loads of fun with it. Donauwörth, January 2004...
- Page 8 PowerBox Systems Modellbau-Deutsch Hindenburgstraße 33 86609 Donauwörth Tel: +49-0906-22559 Fax: +49-0906-22459 info@PowerBox-Systems.com www.PowerBox-Systems.com...
Need help?
Do you have a question about the PowerBox 12 and is the answer not in the manual?
Questions and answers