The Get Command; The Set Command - Aanderaa 4330 Operating Manual

5.5.1 The Get Command

The Get command is used for reading the value/values of a property and for reading the latest value of a
parameter.
The command name Get
Property ProductNo SerialNo Value, ..Value
The string starts with the name of the property, the product number and serial number of the sensor, and
finally the value of the property, refer example in Figure 5-3.
The command name Get
product and serial number of the sensor, and finally the latest parameter reading, refer example in Figure
5-3.
Figure 5-3 Examples of the Get command.
A special version, Get All, reads out all available properties in the sensor.

5.5.2 The Set Command

The Set command is used for changing a property. Type the corresponding
new setting, refer example in Figure 5-4.
Figure 5-4 Example of the Set command.
Use the Save command to store the new property value. Some properties will require a
change is executed.
followed by a Property returns a string on following format:
followed by a parameter returns the name and unit of the parameter, the
page 31 of 93
TD 269 OPERATING MANUAL
OXYGEN OPTODE 4330, 4831, 4835
June 2017
Get command to verify the
Reset before the