Adjust Watering For Seasonal Changes; Switching Programs - Hunter 600-Z Owner's Manual

Adjust Watering for Seasonal Changes ...............

Press
SEASONAL
ADJUST
Use to increase or decrease the amount of water applied to all stations.
• Bar indicates change. Watering frequency and number of cycles
remain the same. Only cycle time changes. Affects programs A and B.
• Cycle times change in 10% steps, from 10% to 150%.
• Time is rounded to the nearest whole minute; cycle time cannot be
reduced to less than one minute.
• To observe the change in cycle time, select the station before
adjusting the cycle time.
EXAMPLE: It's been an exceptionally hot and dry month. You don't
want to reset your programs for a single month. Instead, increase all
watering (both programs) to 130 percent of normal by pressing
three times. Next month, return to normal watering by pressing
three times.

Switching Programs ..........................................

Press
A
Display indicates
which program you
are in.
The PSC-Z can store two completely separate programs, A and B.
Each program can control the same or different stations, and can
have a different start time, cycle times, cycles per day and days apart.
• The Time/Day, Seasonal Adjust and Rain buttons apply to both
programs.
• Start Times, No Water Days, and adjusted Cycle Delay apply to
each program.
• Program B's Start Time is initially set to 0:FF (program is off).
• The PSC-Z avoids program overlaps between A and B by waiting for
one program to complete before beginning the other.
EXAMPLE: After setting up the system, you want to run a short
cycle on every station. Use Program B to set short run times for
each station, then manually run Program B (press ALL STATIONS).
B
To display:
STATION
PROGRAM A
NEXT WATER WED
To display:
STATION
PROGRAM A
NEXT WATER WED
CYCLES
PER DAY
DAYS
APART
CYCLE TIME
CYCLES
PER DAY
DAYS
APART
CYCLE TIME
11