The Fpm-8200 Back Panel; Gpib Connector; Ac Line Power Input; Figure 2.4 Fpm-8200 Back Panel - ILX Lightwave FPM-8200 User Manual

FR O N T PA N E L O P E R A T I O N
2
C H A P T E R

The FPM-8200 Back Panel

The FPM-8200 Back Panel
This section describes the back panel on the FPM-8200.
Chassis

GPIB Connector

Ground
AC Line
Analog Output
Power Input
(BNC)

Figure 2.4 FPM-8200 Back Panel

GPIB Connector
The GPIB connector is located at the top center of the back panel. See Chapters
Three and Four for more information about GPIB control.

AC Line Power Input

The FPM-8200 meter must be connected to a properly rated AC source in order to
operate. Line voltage and frequency limits are defined in Specifications on page 2.
You are responsible for ensuring the connection meets your local electrical code
requirements. In most cases, ILX Lightwave Customer Service can supply special
power cords.
To avoid electrical shock hazard, connect the FPM-8200 only to a properly earth-
grounded, 3-prong receptacle. Failure to observe this precaution can result in severe
injury or death.
If your FPM-8200 meter does not turn on (no response) with AC power applied,
make sure that AC power is available at the instrument end of the power cord:
simply plug the power cord into another working instrument. If this cord is okay,
contact ILX Lightwave Customer Service.
13
01_10 FPM-8200
