Change Compressor Air Filter - Lincoln Electric Air Vantage 600 Owner's Manual

2.9.6 Tighten the filter an additional 3/4 to 1 turn to seat the sealing
gasket.
Never over-tighten the filter, as this may damage the
seal or filter.
2.9.7 Follow the oil level checking procedure in Section 2.4.

2.10 Change compressor air filter

Follow all safety precautions. For ease of service the air filter
is located on the roof of the welder. The filter is also
equipped with a filter minder.
Air filter assembly and air filter element are supplied by
Lincoln Electric Company. Please your contact a Lincoln
Electric service representative for replaceable components
2.10.1 Clean loose dust and debris from the area around the filter
cover to prevent contaminants from entering the system.
2.10.2 Remove the air filter cover retaining clamps and the cover.
2.10.3 Immediately cover the air intake to prevent contamination
entering the intake hose and compressor.
Do not use compressed air or perform any other tasks
around the filter and cover until both are replaced. Never
clean the filter element with compressed air, as this will allow
some contaminates into the compressor system. Always
replace the air filter element.
2.10.4 Remove the filter element from the filter cover. Clean
the inside of the cover with a clean, dry cloth.
Do not use flammable solvents to clean the inside of the
cover. If a solvent has been used rinse the cover thoroughly
with water and dry it before installing the cover. Fire in the
compressor can cause an explosion.
2.10.5 Remove the cloth from the compressor air intake.
2.10.6 Place the filter into the cover and secure it with the cover nut/
clamps.
VMAC – Vehicle Mounted Air Compressors
Toll Free: 1-888-241-2289 Local: 250-740-3200
Fax: 1-250-740-3201
23