Table of Contents
Advertisement
12-pin FPC Connector
The following table lists the pin functions of the 12-pin FPC connector.
Table 4-1
PIN#
Signal
1
NC
2
VIN
3
GND
4
RXD/USB_D-
5
TXD
6
nCTS/USB_D+
7
nRTS
8
PWRDWN
9
nBEEPER
O,od Beeper output
10
nGoodRead
O,od Good Read LED output
11
PIN11
12
nTRIG
※ I = Input; O = Output; od = Open Drain;
※ 1 This output signal can be used by an external LED to indicate power-on status.
The PWRDWN pin (PIN 8) produces a high output when the scan engine is powered on. The Power On LED can be
programmed On or Off. To learn how to program it, please see the EM2037 V4 user guide.
For the external LED circuit design, please see the "Power On LED Circuit" section in this chapter. If the PWRDWN pin
is not used, leave it unconnected.
※ 2 This output signal can be used by an external beeper circuit to generate audible feedback to the user to indicate
power-on and good read statuses.
Power On beep: The nBEEPER pin (PIN 9) produces a PWM output (duration: 400ms; frequency: 4184Hz, both
parameters are NOT user-programmable) 970ms after power-on. The beep can be programmed On or Off. To learn
how to program the parameter, please see the EM2037 V4 user guide.
Good Read beep: The nBEEPER pin (PIN 9) produces a PWM output (default duration: 80ms; default frequency:
2730Hz, both parameters are user-programmable) when a good read occurs. The beep can be programmed On or Off.
To learn how to program these parameters, please see the EM2037 V4 user guide.
For the external beeper circuit design, please see the "Beeper Circuit" section in this chapter. If the nBEEPER pin is
not used, leave it unconnected.
※ 3 This output signal can be used by an external LED to indicate good read status.
I/O
-
-
Power supply input
-
Power-supply ground
I
TTL level 232 receive data/ USB D- differential data signal
O
TTL level 232 transmit data
I
TTL level 232 clear to send /USB D+ differential data signal
O
TTL level 232 request to send
O
Power On LED output
-
Reserved
I
Trigger signal input
Function
Remark
Not connected
See Note 1
See Note 2
See Note 3
Not connected
See Note 4
20
Advertisement
Table of Contents
