Table of Contents
Advertisement
Ilumen
2. Drill the holes
3. Insert the wall plugs (if necessary)
4. Screw the Ilumen PID to the mounting surface and make sure adequate washers are
installed.
5. Check if mounted securely
6 E
LECTRICAL CONNECTIONS
When installing the Ilumen PIDbox, the DC side of the PV plant must be switched off. After the
installation is done, you can switch on the PIDbox by inserting the AC-plug. The green LED
should burn immediately. After this you can switch on the DC-circuit breaker again inside the
inverter of DC-combiner box.
6.1 AC-
CONNECTION
A standard 1 phase AC connection (230VAC (standard) or 110VAC (on request)) must be
available on installation. This supply should be on at all times.
Make sure that a residual-current device of maximum 300mA is also present in this circuit.
Connect the L, N and earth cable to the clamps in the AC-connector using a max of 1,5mm².
•
PE: earth connection
•
1: Neutral
•
2: Line 230VAC
Connect the AC-connector on the left side of the PIDbox. Make sure it is tightened and facing
down.
Installation Manual Ilumen PIDbox v2.5
7
Advertisement
Table of Contents
