Table of Contents
Advertisement
Ilumen
8 I
NSTALLATION SUMMARY
1) Take the necessary safety precautions (DC switch of the inverter off).
2) Mount the Ilumen PIDbox correctly to a wall using the mounting holes.
3) Connect the Ilumen PIDbox earth connector to the frames of the PV modules and check
the interconnections between the PV casings.
4) Disconnect the PV array cables from the inverter.
5) Mind the maximum allowed current through the DC circuit breakers of the PIDbox
6) Connect the PV array cables to the Ilumen PIDbox inputs (see 6.4 for details).
7) Connect the Ilumen PIDbox to the inverter (see 6.3 for details).
8) Plug in the AC connector in the PIDbox
9) Switch on the AC power with the dedicated circuitbreaker
10) Turn on the DC switch inside the inverter and in the DC combiner boxes
9 D
ECOMMISSIONING THE
9.1 D
ISASSEMBLING THE
Switch off the DC to the Ilumen PIDbox by switching off the inverter or the DC combiner box.
Then switch off the AC power to the PIDbox. Disconnect the Ilumen PIDbox from the AC grid.
Wait a minimum of 20 minutes. Disconnect the DC cables from the PIDbox . Disconnect all earth
connections.
When all electrical connections are disconnected you can dismount the Ilumen PIDbox .
When doing any kind of work on the PIDbox , always switch off the DC power to
the device inside the inverter or the DC combiner boxes.
9.2 P
ACKING THE
To pack the PIDbox use the original packaging or packaging suitable for the weight and
dimensions of the PIDbox (see Section 12 "Technical Data").
9.3 D
ISPOSING OF THE
Dispose of the PIDbox at the end of its service life in accordance with the disposal regulations for
electronic waste currently applicable at the installation site.
Installation Manual Ilumen PIDbox v2.5
I
LUMEN
PID
BOX
PID
BOX
PID
BOX
PID
BOX
15
Advertisement
Table of Contents
