Control Test - Bayer HealthCare Ascensia Elite XL User Manual

5
SECTION

Control Test

A Control Test is run to find out if the whole system
is working correctly (Test Strip and Meter) and to
practice good technique before blood glucose testing.
8
Prepare for the Test:
1. To open the Test Strip foil packet,
carefully peel the foil back until
the Test Strip is completely
exposed (as shown). Save the
foil packet.
Note: Numbers printed on each Test Strip
are manufacturing numbers and are not to
be confused with Code Numbers (F#).
2. Holding the round end of the
Test Strip, insert the strip into the
Meter until it stops.
3. A beep sounds. A full display, fol-
lowed by the Code Number (F#)
and previous test result, appears.
The Code Number and previous
test result flash alternately.
4. To mark a Control Test, pull the
Test Strip out and reinsert quickly
(within 2 seconds). When the "C-"
and Code Number (F#) begin
flashing, you know the test will
be marked.