Figure 6-18. Microphone And Speaker Wires Re-Assembly; Figure 6-19. Keyboard Flex Cable Connection - Motorola EP450 Basic Service Manual

6-14 Display Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General
2. Position the radio
nector located on the bottom of the main board, pushing up the 2 end tabs.
3. Slide the volume potentiometer and frequency switch shafts into their respective holes in the front
cover. Look through the accessory connector opening to make certain that the wires are not
pinched, between shroud and housing.
4. Push the topside of the board chassis upward until it touches the housing end. Before snapping
the board into the housing, perform the following checks:
December 3, 2003
More user manuals on
Microphone
Connector

Figure 6-18. Microphone and Speaker Wires Re-assembly

(Figure 6-19), and reconnect the flex connector from the keyboard into the con-

Figure 6-19. Keyboard Flex Cable Connection

a. Open the dust cap and ensure the wires are not pinched between the shroud and housing.
b. Ensure the O-ring is seated in the groove.
c. Ensure that the bottom side of the dust cap is fully pressed into the housing before the
snapping the board into place.
ManualsBase.com
Speaker Connector
Shroud
Radio Chassis
End Tabs
Flex Cable Connector
HKLN4215A