Radio Re-Assembly - Detailed; Dust Cover Re-Assembly; Microphone And Speaker Re-Assembly; Figure 7-9. Dust Cap Re-Assembly - Motorola EP450 Basic Service Manual

7-8 Non-Display Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General
7.4.3

Radio Re-assembly - Detailed

7.4.3.1 Dust Cover Re-assembly

1. Insert the tail of the dust cap into the bottom hole of the audio jacks housing opening
2. Press the dust cap until the tail is fully into the hole.
3. Twist the dust cap counter-clockwise until the cap is seated properly onto the recess.
4. Press the cap again to ensure it fully covers the opening for the audio jack.

7.4.3.2 Microphone and Speaker Re-assembly

1. Check that the speaker felt is in position and is not damaged. If damaged replace felt.
2. Insert the microphone sub-assembly into the microphone boot.
3. Insert the Boot and microphone sub-assembly into the microphone recess in the housing and
route the wires as shown in
4. Locate the speaker tab and align it with the tab opening in the front housing
5. Insert the speaker tab into the speaker recess in the housing. Ensure the speaker is seated flush
in the housing
December 3, 2003
More user manuals on
1 2

Figure 7-9. Dust Cap Re-assembly

Figure

Figure 7-10. Microphone Re-assembly

ManualsBase.com
3
7-10.
Microphone
Boot
Microphone Recess
Microphone Position
(Figure 7-9).
4
(Figure 7-11).
HKLN4215A