Squelch Tuning; Manual Squelch Tuning; Figure 5-10. Squelch Tuning Window; Table 5-5. Squelch Deviation Values - Motorola EP450 Basic Service Manual

5-12
5.5.2

Squelch Tuning

Note: 1. Squelch tuning can only be accomplished after reference oscillator warping.

5.5.2.1 Manual Squelch Tuning

Perform the squelch tuning procedure as follows:
1. Under the Rx Align menu, select Squelch Attenuation. Select Squelch Attenuation 12.5 kHz
or Squelch Attenuation 25 kHz Channel Spacing variations
2. Apply an RF signal modulated with a 1 kHz tone at 60% rated deviation listed in
rent frequency point (F1 being the first) of 10 dB SINAD. That is, adjust the reference signal level
until 10 dB SINAD is obtained at the SINAD meter. Squelch tuning can either be done manually
(see Manual Squelch Tuning for procedure) or by Auto Squelch (see Manual Squelch Tuning for pro-
cedure). To obtain 10 dB, unmute the radio first by dragging the corresponding slider value to 1.
December 3, 2003
More user manuals on
2. When using the test box RLN4460, the received audio output is taken from the AC/
DC METER OUT terminals with the METER OUT rotary switch set to RX. It is recom-
mended that Rated Volume Tuning be performed so the correct 10 dB SINAD level can
be obtained.
3. This tuning method is performed for multiple squelch tuning channels and multiple
channel spacings.

Figure 5-10. Squelch Tuning Window

Table 5-5. Squelch Deviation Values

Channel Spacing
25 kHz
12.5 kHz
20 kHz
ManualsBase.com
Radio Alignment Procedures: Receiver Tuning
Rated System Deviation
5.0 kHz
2.5 kHz
4.0 kHz
(Figure 5-10).
Table 5-5
Signal Generator Deviation
3.0 kHz
1.5 kHz
2.4 kHz
for cur-
HKLN4215A