Table of Contents
Advertisement
5 TRANSPORTATION AND STORAGE
5.1 Turnstile storage
It is forbidden to subject the turnstile to jerks and impacts during storage. Transportation trolleys
to be used for handling of the turnstile. In storage facilities there should not be aggressive gases
and vapours causing metal corrosion.
Air temperature during storage should not be below +5
humidity should not be more than 80% at the temperature 20° С.
5.2 Turnstile transportation
The ready-to-install turnstile to be transported according to the transportation regulations related to
the relevant mode of transport, such as:
– in railway or special containers;
– in closed vehicles;
– waterborne (in ship's hold) .
Transportation on open platforms is allowed. In this case the packed turnstile to be covered with
canvas. Air temperature during transportation should not be below -40°С and above +50°С.
After transportation or storage of the turnstile at negative temperatures or increased humidity the
turnstile to be kept indoor with normal climatic conditions without original packing within 12
hours before commissioning:
1) ambient temperature: + 15°С to +35°С;
2) relative humidity: 45% to 80 %;
3) atmospheric pressure: 84,0 to 106,7kPa (630-800 mm Hg).
6 DISPOSAL
The turnstile design does not contain materials environmentally hostile and hazardous to human
health and special measures are not required for its disposal.
7 MANUFACTURER'S WARRANTY AND TERMS OF WARRANTY MEAINTENANCE
7.1. The manufacturer guarantees good state and declared quality of the turnstile if conditions of
transportation, storage, installation and operation are observed by the consumer.
7.2. The turnstile warranty period is 12 months from the date of sale, unless otherwise specified by
delivery contract.
7.3 During the warranty period the Manufacturer shall undertake to perform repair or replacement
within 10 days (at the discretion of Manufacturer) of the failed turnstile or its parts having proven
factory defects (not due to nonobservance of storage, transportation, installation and operation
conditions specified by this OM) preventing further use of the turnstile.
7.4 The Manufacturer shall not bear responsibility and warranty liabilities for the
consequences (damage) due to nonobservance of the conditions specified by this OM.
7.5 The Manufacturer's warranty liabilities are valid only if sections 3, 4, 5 of the Data Sheet and
warranty coupon are completed as well as the relevant signatures and seals are available. The
turnstile to be repaired only by the authorized service center of the manufacturer with use of
exclusively original spare parts. The warranty liabilities shall not include free-of-charge arrival of
technical staff to the Customer for repair.
С and above +40
С and relative air
0
0
39
Hide quick links:
Advertisement
Table of Contents
