Instrumentation, Tools And Accessories - Tiso BASTION-M Operating Manual

After the signal is deactivated from the input (in1) or deactivation of the panic mode from control
panel, a barrier rod is automatically reset to its initial position.
Before turning on the power and turning off the panic, you need to manually check the verticality of
the barrier rod (if necessary, lower the leash manually to the stop). After full recovery - check the
blocking of all three barrier rods.
a) The positions of the rod in the
"PANIC" mode before restoring
Fig.7 - Deactivation of the "PANICA" mode and restoration of the leash to the starting position
More detailed description of the turnstile operation modes is given in section 1.8 "Description
and operation of controller as a component of the turnstile".
1.4.3.4 The turnstile 12V DC power voltage is provided by power supply unit.
1.4.3.5 The turnstile wiring diagram is shown in Annex C.

1.5 Instrumentation, tools and accessories

Dedicated tools are not required for installation of the turnstile (multi-purpose
measurement instrumentation and installation tools are sufficient (See Fig. 8) ).
 puncher;
 concrete drills (according to diameter of anchors included in the turnstile scope of delivery) ;
 extension cord ;
 kit of end and pin wrenches ;
 kit of hexagons ;
 kit of screwdrivers ;
 hammer ;
 multimeter (tester) ;
measuring tape
 marker ;
 pliers, side cutters;
 builder's level.
b) The positions of the restored rod
in the "Standby"mode
Fig. 8 - Tools and accessories for installation
13