Preparation For Use - Tiso BASTION-M Operating Manual

b) Control panel link cable to be connected to the
terminals (Fig.18):
- P (Power) – control panel power supply +12V
- G (GND) - control panel common wire;
- A (RSA) - RSA wire of control panel link line;
- B (RSB) - RSB wire of control panel link line;
c) Proximity card readers
system (ACS) is available:
- In the turnstiles CENTURION, TWIX, SKULL
and BASTION card readers are installed on special
and height adjustable bracket, which is located
under upper lid 4 next to LED display 3 (Fig. 19).
- Maximum sizes of the card reader to be installed are at least 100х100х25 mm*;
14) The turnstile to be secured with anchors included in the scope of delivery.
15) The turnstile rack lid to be installed in the removal reverse sequence.
16) The turnstile door to be installed in the removal reverse sequence.
WARNING:
During the turnstile installation it should be taken into account that horizontally
positioned barrier rod must be at a distance not more than (50 ÷ 100) mm from
access way creator (any surface perpendicular to
barrier rod: enclosure module, wall, etc.).

2.3 Preparation for use

2.3.1 Commission guidelines
Prior to the turnstile energization:
1) make sure of proper connection and good condition of all connecting cables;
2) the turnstile barrier rod turning area to be cleaned from foreign particles.
When mains cable of power supply unit is connected to network the turnstile control mechanism
are energized: barrier rods are locked from rotation in both directions barring access.
The turnstile is set in the initial state: red cross is displayed for entry and exit (« × » is lit).
2.3.2 Required inspections
2
Is not included in the scope of delivery
to be installed if access control
2
Fi.19 – Installation of card reader
into the tripod turnstile
horizontally positioned
32