Description And Operation Of Controllers As Components Of The Turnstile - Tiso BASTION-M Operating Manual

1.6 Description and operation of controllers as components of the turnstile

1.6.1 Motorized mechanism controller РСВ.201.01.00.00
The controller is designed for acquisition of commands from the turnstile controller
PCB.112.21.20.00 and generation of signals controlling motor and the motorized mechanism
locking solenoids.
1.6.1.1 The controller is assembled on the (85 х 70mm) board, on which electronic components
and connectors for external connections are mounted.
13 LEDs are installed on the controller board. Their purpose is as follows:


" "

1.6.1.2
Number of inputs
Number of outputs
Type of inputs
Type of outputs «GRN1», «RED1», «GRN2», «RED2»
Logical «1» voltage
Logical «0» voltage
Maximum peak voltage applied to inputs «IN1»÷« IN8»
Peak voltage switched by outputs «GRN1», «RED1», «GRN2»,
«RED2»
Peak current switched by outputs «GRN1», «RED1», «GRN2»,
«RED2»
Peak voltage switched by outputs «-MG1», «-MG2»
Peak current switched by outputs «-MG1», «-MG2»
Peak voltage switched by outputs «MOT1», «MOT2»
Peak current switched by outputs «MOT1», «MOT2»
Controller supply voltage
Consumption current when outputs «MOT1» and «МОТ2» are OFF
Climatic modification and location category according to GOST
15150-69
The controller appearance is shown in Figure 9.
Parameter description
motor
5.
14
Table 5
Parameter value
2
4
logical
open collector
(3,7  5) V
(0  1,7) V
15 V
30 V
2 А
50 V
5 A
27 V
≤ 4 А
(10  27) V
≤0,15 А
MC4