Nortel BCM50 2.0 Installation Manual page 53

Figure 12 IP Phones
Services key
2001/2002/2004
Tool icon
Press the button sequence within 1.5 seconds; otherwise the telephone does not enter configuration
mode.
Manual Cfg DHCP(0 no, 1 yes)
• If
configuration mode.
• If any other message appears, disconnect, then reconnect the power, and try to access the
configuration mode again.
4
Enter the network parameters, as prompted.
As each parameter prompt appears, use the keypad to define values.
Use the * key to enter the period in the IP addresses.
Press OK to move forward.
After you have entered all the configuration information, the telephone attempts to connect to the
Locating Server
system. The message
the message changes to
several minutes. Do not disturb the telephone during this time.
When the telephone connects to the server and is ready to use, the display shows the time and date.
As well, the six keys at the top of the display are labelled.
If you experience problems with IP telephone registration, refer to the section:
IP telephones" on page
Chapter 7 Registering Nortel 20XX and 11XX IP telephones
Display
buttons
Services key
2007
appears on the screen, you successfully accessed the
appears on the display. If the connection is successful,
Connecting to Server
55.
2033
1120E/1140E
after about 15 seconds. Initialization can take
Telephony Device Installation Guide
53
"Troubleshooting