Wdr - Patlite WDT-5LR-Z2 Instruction Manual

(2)

WDR

Power LED indicator (green) does not light up.
Power LED indicator (green) and output LED
indicator (red) are flashing.
Contact output does not output.
The host and USB are connected, but
communication does not work.
The host and LAN are connected, but
communication does not work.
There is no notice on the host that the WDT
has powered down.
Issue
Wireless Data Acquisition System Instruction Manual
When using the DC jack, connect only the supplied AC
adaptor.
When using the power terminal block, check the polarity
(+/-) of the power lines and turn on the power supply.
When power is supplied from an USB cable, do not use a
hub.
Normal operation may not be possible as the current may
be insufficient.
There may be a problem with the hardware.
Please contact your local sales representative.
Wire correctly and check the operation.
Send the correct command.
Select the correct port and connect the COM port.
Operation when connecting via a hub has not been
confirmed. Use this product by connecting directly to the
USB port.
Default is 192.168.0.1:10001. If you changed the IP
address, set that IP address and connect. If you do not
know the IP address anymore, initialize the LAN
communication settings and check the communication
again.
Refer to ☞ "7.2(2) WDR Wiring".
Notices from the 30th or later connected WDT is not
output.
58
Checklist