Equipment Settings; Equipment Installation; Wdt Installation - Patlite WDT-5LR-Z2 Instruction Manual

* 1 For this product's settings, select the "Power line". For more information, refer to ☞ "WDS-WIN01 Instruction Manual".
* 2 For network startup method, use "Auto Startup". For more information, refer to ☞ "WDS-WIN01 Instruction Manual".
* 3 Prepare beforehand the number of IP addresses required for use with the WDR.
◆ Information about settings is required not only for installing equipment, but also when adding equipment, maintaining
the system, relocating, and for efficient and accurate work. Prepare the setup information before starting installation.
(2)

Equipment Settings

 Using the setup information in 6.3(1), begin the setup.
 For information on system configuration when setting up the equipment, refer to ☞ "5.2(2)② Maintenance System
Configuration (using the power supply input kit)
 Use the system configuration software WDS-WIN01 for equipment settings.
 Install WDS-WIN01 on the maintenance PC and set up the equipment.
 For using WDS-WIN01, refer to ☞ the "WDS-WIN01 Instruction Manual".
 The setup procedure is as follows.
Step
Prepare required equipment and create
1
maintenance environment
Communication settings between WDR and
2
Maintenance PC
3 WDT setup
4 WDR setup

6.4 Equipment Installation

◆ When deciding the installation location of each device, carefully review the following procedure
Mandatory
◆ Install each device after completing equipment settings.
(1)

WDT Installation

 The steps for installing the WDT are as follows.
Step
1 Wire the LR series signal tower.
2 Attach the WDT to the LR series signal tower.
Item
regarding installation location. The installation location could cause problems such as unstable
operation or communication failure.
Item
Wireless Data Acquisition System Instruction Manual
NOTICE
Refer to ☞ "WDS-WIN01 Instruction Manual".
Refer to ☞ "7.1(3) Setting up the WDT Main Unit"
Refer to ☞ "7.1(4) WDT DIP Switch Operations"
CAUTION
Refer to ☞ "7.1(1) WDT Wiring"
Refer to ☞ "7.1(2) Attaching and Detaching the
WDT"
28
References
References