(1-4) WDR Installation Position and Obstacles
When installing onto a pillar such as the I-beam in a building, install the WDR in a direction that promotes the propagation of
radio waves.
When storing the WDR in a box, use a resin box with radio wave permeability.
(2)
About the Signal Tower Power Supply status
To operate the WDT, you need to constantly supply power to the LR series signal tower's power line.
For more information, refer to ☞ "7.1 Wiring".
6.3 Equipment Settings
This section describes the steps for setting up and installing equipment. Refer to ☞ "7 Operation" as well as instruction
manuals of related products.
(1)
Setup Information
Have the information for the settings below prepared beforehand.
Information required
Information about the
equipment to connect
Information about the
target Signal Tower
WDT and WDR
common settings
WDT settings
WDR settings
Equipment name and other identifiable equipment information
Model, power supply specifications, operation information
Wireless settings
Run time settings
Simple counter function
Wireless settings
Network startup method
LAN communication
DNS server port number
Wireless Data Acquisition System Instruction Manual
Description
ExtendedPanID
Wireless channels
Determine Signal
Tower Input
Power supply settings
Transmission mode
IP address
Subnet mask
Default gateway
27
Refer to ☞ "6.1(2) About
Grouping and ExtendedPanID"
Refer to ☞ "6.1(1) What is the
WD Wireless Network?"
Refer to ☞ "8.1(2)① Determine
Signal Tower Input"
*1
Refer to ☞ "8.1(1)⑥Selecting
the signal wire for a simple
counter"
Refer to ☞ "8.1(1) Functions
Related to Wireless Data
Transmission"
*2
*3
–
–