Electrolux N7E Installation And Operating Manual page 21

2. Remove the front panel of the appliance;
3. Connect the power cable to the terminal block as shown in
the wiring diagram attached to the appliance;
4. Secure the power cable with the cable clamp;
E E . . 1 1 1 1 . . 1 1 P P o o w w e e r r c c a a b b l l e e
Unless otherwise specified, our appliances are not equipped
with a power cable.
The installer must use a flexible cable having characteristics
not lower than the H07RN-F rubber insulated type.
Protect the section of cable outside the appliance with a metal
or rigid plastic tube.
W W A A R R N N I I N N G G
If the power cable is damaged, it
must be replaced by the after-
sales service or in any case by
specialised personnel, in order
prevent any risk.
W W A A R R N N I I N N G G
The manufacturer declines any
liability for damage or injury
resulting from breach of the
above rules or non-compliance
with the electrical safety regula-
tions in force in the country
where the machine is used.
F F I I N N S S T T R R U U C C T T I I O O N N F F O O R R T T H H E E U U S S E E R R
F F . . 1 1 B B r r a a i i s s e e r r u u s s e e
General precautions
• The appliance is intended for industrial use by trained
personnel.
• This appliance must only be used for its expressly designed
purpose; i. e. for cooking or preparing meats with sauce,
braised and stewed, sauces, light fries, omelettes and
stewing or dry cooking in general. Any other use is
deemed improper.
• Do not use the appliance as a fryer; the temperature of the
tank bottom exceeds 230℃ with risk of the oil burning.
• It is advisable not to use appliances with iron bottom for
cooking tomato sauces and foods with "acid" content.
Appliances with iron bottom:
Before first use, it is advisable to clean the tank and prepare it
for cooking, as follows:
• Boil water, vegetables and salt, setting the braiser to
maximum;
E E . . 1 1 1 1 . . 2 2 E E q q u u i i p p o o t t e e n n t t i i a a l l n n o o d d e e a a n n d d E E a a r r t t h h c c o o n n n n e e c c t t i i o o n n
• Connect the appliance to an earth;
It must be included in an equipotential node by means of the
screw located under the appliance frame at the back right
hand side.
The screw is marked with the symbol
E E . . 1 1 1 1 . . 3 3 C C i i r r c c u u i i t t b b r r e e a a k k e e r r
Verify that a safety circuit breaker is installed between the
power cable of the appliance and the mains electric line.
The contact opening maximum distance and leakage current
must comply with the local safety regulations.
E E . . 1 1 1 1 . . 4 4 E E q q u u i i p p o o t t e e n n t t i i a a l l n n o o d d e e a a n n d d E E a a r r t t h h c c o o n n n n e e c c t t i i o o n n
Connect the appliance to an earth; it must be included in an
equipotential node by means of the screw located at the front
right under the frame.
The screw is marked with the symbol
E E . . 1 1 2 2 W W a a t t e e r r c c o o n n n n e e c c t t i i o o n n
The water connection must be carried out by a specialised
technician.
The appliance must be supplied with drinking water at a
pressure of 1.5 - 3 bar.
C C A A U U T T I I O O N N
If the 1.5 – 3bar is higher than that
specified, use a pressure reducer to
avoid damaging the appliance.
• For correct installation, connect the water inlet pipe to the
mains by means of a mechanical filter and a shutoff tap.
• Before connecting the filter, allow a certain amount of water
to flow in order to clear the pipe of any waste matter.
E E . . 1 1 3 3 S S a a f f e e t t y y t t h h e e r r m m o o s s t t a a t t
Some of our appliance models use a safety thermostat that
cuts in automatically when temperatures exceed a set value,
shutting off the gas supply (gas appliances) or the electricity
(electric appliances).
I I M M P P O O R R T T A A N N T T
Resetting of the safety thermostat must be
carried out by specialised personnel; con-
tact the Service Centre.
Tampering with the safety thermostat
invalidates the warranty.
• Boil off the water and clean any still moist vegetables from
the bottom of the braiser using a cloth;
• Spread a layer of oil (2mm) in the tank and heat at minimum
until drying it;
• Clean the braiser thoroughly, drying it.
Duomat steel bottom appliances:
Before use, carefully clean any industrial greases from the
tank, proceeding as follows:
• fill the tank with water and normal detergent and bring to boil
for a few minutes.
• empty and rinse thoroughly with clean water.
C C A A U U T T I I O O N N
Preheating dry with the lid lowered could
cause intervention of the limiter.
.
.
21