Electrolux N7E Installation And Operating Manual page 10

A A . . 6 6 T T r r a a n n s s p p o o r r t t , , h h a a n n d d l l i i n n g g a a n n d d s s t t o o r r a a g g e e
• Due to their size, the machines can be stacked on top of each other
during transport, handling and storage by complying with that specified
on the slip placed on the packing.
• Do not stand under suspended loads during loading/unloading
operations. Unauthorised personnel must not enter the work area.
• The weight of the appliance alone is not sufficient to keep it steady.
• For machine lifting and anchoring, do not use movable or weak parts
such as: casing, electrical raceways, pneumatic parts, etc.
• Do not push or pull the appliance to move it, as it may tip over.
• Machine transport, handling and storage personnel must be
adequately instructed and trained regarding the use of lifting systems
and personal protection equipment suitable for the type of operation
carried out (e.g. overalls, safety shoes, gloves and helmet).
• When removing the anchoring systems, make sure the stability of the
machine parts does not depend on the anchoring and, therefore, that
this operation does not cause the load to fall off the vehicle. Before
unloading the machine components, make sure all the anchoring
systems are removed.
• Machine positioning, installation and disassembly must be carried out
by specialised personnel.
A A . . 7 7 I I n n s s t t a a l l l l a a t t i i o o n n a a n n d d a a s s s s e e m m b b l l y y
• The operations described must be carried out by personnel qualified
(refer to D.1 Characteristics of personnel trained for normal machine
use ) in compliance with the current safety regulations, regarding the
equipment used and the operating procedures.
• The plug, if present, must be accessible after positioning the appliance
in the place of installation.
• Disconnect the appliance from the power supply before carrying out
any installation procedure.
A A . . 8 8 E E l l e e c c t t r r i i c c a a l l c c o o n n n n e e c c t t i i o o n n
Before connecting, make sure the mains voltage and frequency match
those indicated on the appliance data plate.
• Work on the electrical systems must only be carried out by specialised
personnel.
• Connection to the power supply must be carried out in compliance with
the regulations and provisions in force in the country of use.
• If the power cable is damaged, it must be replaced by the After-Sales
Service or in any case by specialised personnel, in order to prevent any
risk.
10