Technical Operation; Instruction On Maintenance Of A Digger; After-Seasonal Maintenance Of The Digger - Bomet Z655/1 Owner's Manual

of the digger should be installed in the brackets so that the right wheel does not press a
neighboring ridge.
WARNING
All clogging made during work of the digger requiring interference in the operation, shall
be removed after stopping the tractor, lowering the digger onto the ground or support,
turning off the tractor engine and pulling the handbrake.
In case of clogging of the machine and when elements were not automatically cleaned, it is
necessary to stop the tractor, turn off the tractor engine and then manually or with the use of
special tools remove the accumulated contamination. If the digger must be raised for
removing the contamination, it is necessary to put a support securing against its falling down
(e.g. a wood block). During operation and especially in the first period of using, it is
necessary to pay particular attention to backlash of screw connections. Therefore, it is
necessary to check and tighten screw connections after stopping the tractor and turning off
the tractor engine.
Caution
Returns shall be performed easily with the digger raised to the transportation position,
with no use of the tractor independent brake. It is necessary to keep extreme caution if
there are people or items in the range of the digger operation.
Caution
It is not allowed to use tractor reverse gear during work, when the machine is in the
working position. The digger shall be raised easily, without jerks or vibrations.
Caution
It is inadmissible to leave the digger on the slope or other terrain slope without securing
it against automatic rolling down.

5. TECHNICAL OPERATION

To ensure a lasting and reliable operation of the digger, condition of screw
connections should be checked and tightened in case of loosening. After work, the digger
should be cleaned thoroughly.
replaced following these recommendations:
- all worn elements of the digger shall be exchanged in the proper time,
for exchange only original parts ensuring good quality shall be used, it comprises one
-
of conditions of keeping warranty validity.

5.1. Instruction on maintenance of a digger

Each time, after work, clean the digger out of soil and other contamination, especially
clean thoroughly shake hoppers and ploughshare out of haulm residues and soil. Then
review of connection of parts and units shall be performed. Technical operation of the digger
consists in checking the state of topper ploughshare, shake hoppers and the drive shaft with
eccentrics and also checks the state of screw and pivot connections and the state of welds.
All loose screw connections shall be tightened. Pivots and studs of the digger suspension
system should not be lubricated but kept in a clean and dry condition. Warning signs and a
triangular sign for low-speed vehicles shall be kept clean.
Caution
All maintenance shall be performed at the digger lowered onto the ground and the tractor
engine stopped using personal protection measures (e.g. gloves).

5.2. After-seasonal maintenance of the digger

After season, the digger shall be cleaned thoroughly out of contamination and washed.
Worn or damaged working parts shall be exchanged and all loose screw connections
Worn or damaged working parts of the digger shall be
- 20 -