Introduction; Intended Use Of The Digger - Bomet Z655/1 Owner's Manual

1. INTRODUCTION

This manual is attached to each machine to make a user acquainted with construction,
operation and adjustment of the 1-row vibrating digger. Its aim is also warning about existing
or possible threats. The manual also contains information on preparation of the digger for
operation and for transportation on public roads.
Strict compliance with recommendations included in the content of the manual will
ensure long-term and non-failure operation and contribute to reduction of operating costs of
the machine. Each section of the instruction (according to the contents) presents proper
issues in detail. If there is any unclear information for the user, they can obtain exhaustive
explanation by writing to the manufacturer's address (the address is on the cover) – you are
asked to give: exact address of the purchaser of the machine, machine symbol, serial
number, year of production, year and number of issuing the manual.
Terms used in the manual: left side, right side, back and front – refer to the settings of
an observer with his face turned according to the direction of the machine drive.
Warranty proceedings regulations and rights resulting from them, are given in the
warranty card, attached to each digger.

2. INTENDED USE OF THE DIGGER

1-row vibrating digger is intended to operate exclusively in the agriculture. Using it for
other purposes shall be understood as using it against the intended use. Meeting
requirements referring to operation of the machine, its maintenance and repairs according to
recommendations of the manufacturer and strictly complying with them state the condition of
using it according to the intended use.
The machine shall be employed and operated only by people acquainted with its
detailed characteristics and with procedures in the field of safety. Regulations concerning
accident prevention and all the basic regulations in the field of occupational health and safety
and also traffic regulations should be always abided by.
Vibrating digger Z655 is a machine mounted on three-point suspension system of the
tractor. The digger
10 KM equipped with normalized power take-off shaft, suspension system category I or II and
front axle standard ballasts for keeping the required controllability factor (s ≥ 0.2).The
machine is equipped with two-sided studs of the lower suspension axle allowing for
aggregation of a digger with tractors of suspension category I (stud of diameter of Ø22 mm)
or category II (stud of diameter of Ø28 mm). The machine is mainly intended for digging up
potatoes from 1 row but it can also gather other root crops and vegetables. The machine can
be employed on light and medium compacted soils, not too stony and at fragmented haulms
on plain terrain and slopes up to 8.5.
Digger submerges in the ridge with a ploughshare taking soil along with potatoes and
then the soil is sifted on two hoppers while potatoes are put on the left side in a narrow strip
in the distance enabling another working passage.
Digger submerges in the ridge with a ploughshare taking soil along with potatoes and
then the soil is sifted on two hoppers while potatoes are put on the left side in a narrow strip
in the distance enabling another working passage. Vibrating digger of Z655/1 series puts
potatoes behind the digger.
The digger can be employed for gathering root crops e.g. onion, carrots etc.
should co-operate
- 9 -
with tractor classes of power of