Elation WW PROFILE HP IP User Manual page 18

Persnal - Stat Set - Addr DMX
When ON, define the desired fixture DMX address via an external controller.
NOTE: This process assumes the fixture DMX address is set to 001. If fixture DMX address is not at 001,
you must adjust the channel numbers listed below accordingly in order for this feature to work.
For example: if your fixture address is 010, then Channel 1 becomes Channel 10, Channel 2
becomes Channel 11, and Channel 3 becomes Channel 12.
1. Connect the fixture to the external controller and power ON.
2. Set the DMX value of Channel 1 on the controller to (7).
3. Set the DMX value of Channel 2 on the controller to (7) or (8).
When set to (7), the DMX address can be set between (1) and (255).
When set to (8), the DMX address can be set between (256) and (511).
4. Using Channel 3 on the controller set the desired DMX address of the fixture.
Example 1: If the desired DMX address is 57, set Channel 1 to a value of (7), set
Channel 2 to a value of (7), and then set Channel 3 to a value of (57).
Example 2: If the desired DMX address is 420, set Channel 1 to a value of (7), set
Channel 2 to a value of (8), and then set Channel 3 to a value of (164).
(256+164=420)
5. After setting Channel 3 to the desired DMX address value, wait approximately
20-45 seconds for the new address to be assigned to the fixture.
Dimming – DimModes
Select dimming modes (Standar, Stage, TV, Archite, Theatre).
www.elationlighting.com
18