Hitachi Virtual Storage Platform G130 Hardware Reference Manual page 22

Number Item
1 POWER
LED
2 READY LED Green
3 WARNING
LED
4 ALARM
LED
5 POWER
ON/OFF
(main
switch)
6 Lock
Note: Removing a controller can cause the POWER, READY, WARNING, and
ALARM LEDs on the front panel to turn off. These LEDs return to their on
state after the storage system recovers from the controller replacement.
The following table describes the definitions of the CBSS controller front panel LEDs
without an attached front bezel.
Chapter 2: Hardware components and specifications
Hitachi Virtual Storage Platform G130 Hardware Reference Guide
Controller chassis with small form-factor drive bays (CBSS)
Color Pattern
Green ON Storage system is powered on.
Amber ON Storage system is receiving power.
ON Storage system is ready for normal
operation.
Amber ON Component requires maintenance.
Blink Failure occurred. Requires maintenance.
When the SIM is confirmed, the LED pattern
indicates the failure and requires attention.
Note: When System Option Mode 1097 is
set to ON, the WARNING LED does not blink,
even if the following failure service
information messages (SIM) are issued:
452xxx, 462xxx, 3077xx, 4100xx, and
410100.
LED might turn off during user
maintenance.
Red ON Processor failure (system might be down).
For assistance, contact customer support:
https://support.hitachivantara.com/en_us/
contact-us.html.
- - Turns on power to the storage system.
- - Locks and unlocks the front panel bezel by
using the supplied key.
Description
22