Seat Belt Warning Beep; Active Bonnet Warning Beep; Rear Seat; Ignition Not Switched Off (Stop) Warning Beep - Mazda CX-8 Manual

Hide thumbs Also See for CX-8:
Table of Contents

Advertisement

If Trouble Arises
Warning/Indicator Lights and Warning Sounds

▼ Seat Belt Warning Beep

Front seat
If the vehicle speed exceeds about 20
km/h (12 mph) with the driver or front
passenger's seat belt unfastened, a warning
beep sounds continuously. If the seat belt
remains unfastened, the beep sound stops
once and then continues for about 90
seconds. The beep stops after the driver or
front passenger's seat belt is fastened.
NOTE
Some models do not have the seat belt
warning beep for the front passenger's
seat.
To allow the front passenger occupant
classification sensor to function
properly, do not place and sit on an
additional seat cushion on the front
passenger seat. The sensor may not
function properly because the additional
seat cushion could cause sensor
interference.
When a small child sits on the front
passenger seat, it is possible that the
warning beep will not operate.

Rear seat

The warning beep only sounds if a seat
belt is unfastened after being fastened.
7-38
CX-8_8GF4-EO-18D_Edition1

▼ Active Bonnet Warning Beep

If there is a problem with the active bonnet
and the warning light illumination, a
warning beep sound will be heard for
about 5 seconds every minute.
The active bonnet warning beep sound
will continue to be heard for
approximately 35 minutes. Have your
vehicle inspected at an expert repairer, we
recommend an Authorised Mazda
Repairer as soon as possible.
WARNING
Do not drive the vehicle with the active
bonnet warning beep sounding:
Driving the vehicle with the active bonnet
warning beep sounding is dangerous as
the active bonnet mechanism may not
activate normally and function as intended
in the event the vehicle were to contact a
pedestrian. Contact an expert repairer, we
recommend an Authorised Mazda Repairer
to have the vehicle inspected as soon as
possible.
▼ Ignition Not Switched Off (STOP)
Warning Beep
If the driver's door is opened with the
ignition switched to ACC, a beep will be
heard continuously in the cabin to notify
the driver that the ignition has not been
switched OFF (STOP). Under this
condition, the keyless entry system will
not operate, the vehicle cannot be locked,
and the battery voltage will be depleted.
2018-3-6 19:38:07

Advertisement

Table of Contents
loading

Table of Contents